Maintenance; Caring For Microwave Oven; Respect For The Environment - Fulgor Milano PROFESSIONAL F6PSPD30S1 Instrucciones Para La Instalación Y Uso

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

MAINTENANCE

Caring for Microwave Oven

Any piece of equipment works better and lasts
longer when maintained properly and kept clean.
Cooking
equipment
Microwave
oven
must
maintained
properly.
cord before cleaning or leave the door open to
inactivate the oven during cleaning.
Exterior
The exterior should be wiped often with a soft damp cloth
and polished with a soft dry cloth to maintain its beauty.
There are also a variety of products designed especially
for cleaning and shining the stainless exterior of the oven.
We recommend that the cleaner be applied to a soft cloth
and then carefully used on the stainless exterior rather than
sprayed directly on to it.
Internal
Food spatters or spilled liquids stick to oven walls and
between the seal and door surfaces. Although the oven
interior has an antibacterial coating, it is best to wipe
up spillovers with a damp cloth right away. Crumbs and
spillovers will absorb microwave energy and lengthen
cooking times and may even damage the oven. Use a damp
cloth to wipe out crumbs that fall between the door and the
frame. It is important to keep this area clean to assure a tight
seal. Remove greasy spatters with a soapy cloth then rinse
and dry. Do not use harsh detergent or abrasive cleaners.
Door Seal
The door and door seals should be kept clean. Use only
warm, soapy water, rinse then dry thoroughly. DO NOT USE
ABRASIVE MATERIALS, SUCH AS CLEANING POWDERS
OR STEEL AND PLASTIC PADS. Metal parts will be easier to
maintain if wiped frequently with a damp cloth.
Waveguide Cover
ATTENTION The waveguide cover, located on the inside top
of the Microwave area, is made from mica, so it requires
special care. Keep the waveguide cover clean to assure
good microwave performance. Carefully wipe with a soft
damp cloth any food spatters from the surface of the cover
immediately after they occur. Built-up splashes may overheat
and cause smoke or possibly catch fire.
Do not remove the waveguide cover.
is
no
exception.
Your
be
kept
clean
and
Disconnect
the
power

Respect for the environment

The documentation for this appliance is printed on paper
bleached without chlorine or recycled paper to contribute
to protecting the environment. The packaging was designed
to prevent damage to the environment; they are ecological
products that can be recovered or recycled.
Recycling the packing saves raw materials and reduces the
volume of industrial and domestic waste.
THE PACKING MATERIAL is 100% recyclable and marked
with the recycling symbol. Dispose of in conformity with
local law. The packing material (plastic bags, polystyrene
parts, etc.) must be kept out of the reach of children because
it is potentially dangerous.
THIS APPLIANCE is marked in conformity with European
Directive 2002/96/EC, Waste Electrical and Electronic
Equipment (WEEE). By making sure that this product is
disposed of correctly, the user contributes to preventing
potential negative consequences for the environment and
health.
THE
SYMBOL
on
the
documentation indicates that this product must not be treated
as domestic waste but must be delivered to a suitable
collection point for the recycling of electrical and
electronic equipment.
DISPOSAL MUST BE MADE in conformity with local laws on
waste disposal.
FOR ADDITIONAL INFORMATION about the treatment,
recovery and recycling of this product, contact the local
office of competence, the domestic waste collection service
or the store where the product was purchased.
BEFORE SCRAPPING, make it unusable by cutting the
electrical cord.
product
or
accompanying
EN
9

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Distinto f7dspd30s1

Tabla de contenido