Charger Mounting; Important Safety Instructions; Correct Disposal Of This Product; Removal Of Waste Batteries And Accumulators - GreenWorks Tools 29717 Manual Del Usuario

WARNING
If the battery is inserted into the charger when warm or
hot, the CHARGING LED indicator light on the charger
may switch on and illuminate ORANGE. If this occurs
allow the battery to cool outside of the charger from
approximately 30 minutes.

CHARGER MOUNTING

1. This charger can be installed hanging on a wall using
two screws (not supplied)
2. Locate the placement for the charger to be wall mounted.
3. If fastening to wood studs use 2 wood screws.
4. Drill two holes 2 3/8" (6 cm) on center ensuring they
are level.
5. If fastening to drywall use wall anchors and screws to
secure the charger to the wall.
NOTE: If the battery and the charger won't be used for a
long time, please remove the battery from the charger and
pull out the AC power plug.

Detachable Power Cord

The power cords of the charger are detachable. They can
be removed from the charger and used interchangeably.
(See the figure below)
① ②
④
③
English (Original Instructions)

IMPORTANT SAFETY INSTRUCTIONS

1. SAVE THESE INSTRUCTIONS - DANGER: TO
REDUCE RISK OF FIRE OR ELECTRIC SHOCK
CAREFULLY FOLLOW THESE INSTRUCTIONS.
2. Confirm the voltage available at each country location
before using the charger.
3. If the sharp of the plug does not fit the power outlet, use
an attachment plug adaptor of the proper configuration for
the power outlet.

CORRECT DISPOSAL OF THIS PRODUCT:

This marking indicates that this product should not be
disposed with other household wastes throughout the
EU. To prevent possible harm to the environment or
human health from uncontrolled waste disposal, recycle it
responsibly to promote the sustainable reuse of material
resources. To return your used device, please use the
return and collection systems or contact the retailer where
the product was purchased. They can take this product for
environmental safe recycling.

Removal of waste batteries and accumulators

Member States shall ensure that manufacturers design
appliances in such a way that waste batteries and
accumulators can be readily removed. Where they cannot
be readily removed by the end-user. Member States shall
ensure that manufacturers design appliances in such a
way that waste batteries and accumulators can be readily
of the manufacturer. Appliances in which batteries and
accumulators are incorporated shall be accompanied by
instructions on how those batteries and accumulators
can be safely removed by either the end-user or by
the instructions shall also inform the end-user of the types
of battery or accumulator incorporated into the appliance.
5