Checking The Oil Level - Troy-Bilt TB635 EC Manual Del Operador

CHECKING THE OIL LEVEL

WARNING:
Check the oil level before each use. The
importance of maintaining the proper oil level cannot be
overemphasized.
1. Stop the engine and allow it to cool.
2. Set the unit on a flat, level surface, such as a workbench or
table. The cutting head shield should hang over the edge so that
the engine is level (Fig. 22).
NOTE: Failure to keep the engine level may result in oil overfill.
3. Clean the area around the oil fill plug (Fig. 23) to prevent debris
from entering the oil fill hole (Fig. 23).
4. Unscrew the oil fill plug.
5. Wipe off the oil from the dipstick (Fig. 24) with a clean cloth.
6. Reinstall the oil fill plug and then unscrew it again.
7. Examine the oil level on the dipstick. Oil should cover the hash
marks (Fig. 24).
• If the oil level is too low, add a small amount of oil to the oil fill
hole. Repeat steps 5 - 7 until the oil is at the correct level.
WARNING:
DO NOT overfill the crankcase.
OVERFILLING THE CRANKCASE MAY CAUSE SERIOUS
PERSONAL INJURY.
• If the oil level is too high, tip the unit and drain the excess oil
into an appropriate container.
8. Wipe up any oil that may have spilled.
9. Make sure the O-ring is in place on the oil fill plug (Fig. 23).
10. Reinstall the oil fill plug.
Oil Fill Plug
O-Ring
Oil Fill Hole
Maximum
Oil Level
Minimum
Oil Level
17
Fig. 22
Fig. 23
Hash
Marks
Fig. 24