Planning The Installation; Lan Ports; Fiber Optic Uplink Port; Console Port - Allied Telesyn AT-iMG606BD Guia De Instalacion

Planning the Installation

LAN Ports

Speed
10 Mbps Category 3 or better 100-ohm unshielded
twisted pair cable
100 Mbps Category 5 or Category 5E (Enhanced) 100-
ohm unshielded twisted pair cable
Fiber Optic
Uplink Port

Console Port

This section describes the cables necessary for the
installation of an AT-iMG606BD Multiservice Gateway.
Table 4 contains the cabling specifications for the LAN
ports.
Table 4. Twisted Pair Cabling and Distances
Type of Cable
Note
The twisted pair ports on the gateway feature auto-
MDI when operating at either 10 or 100 Mbps. Each
port is individually configured as MDI or MDI-X when
connected to an end node. Consequently, you can use
either a straight-through or crossover twisted pair
cable when connecting any network device to a
twisted pair port on the gateway.
For cable and operating specifications for the fiber optic
uplink port, refer to "100Base-FX Fiber Optic Uplink (WAN)
Port" on page 47.
The console port has an eight-pin DIN connector. To order
the AT-RGCONSOLECABLE-00 management cable,
contact your Allied Telesyn sales representative.
AT-iMG606BD Multiservice Gateway Installation Guide
Maximum
Operating
Distance
100 m (328 ft)
100 m (328 ft)
31