Using The Wireless Transmitter / Receiver - Sony IFU-WH1 Serie Manual De Instrucciones

Republic, Turkey, Bulgaria, the United
Kingdom, Australia, and New Zealand.
For customers in other countries
The wireless communication function of
this system is only used in the country
where you purchased the system.
Accessories
• Transmitter (IFU-WH1-TX) (1)
• Receiver (IFU-WH1-RX) (1)
• AC power adaptor (2)
• AC power cord (2)
• Cable for powered USB port (2)
• Operating Instructions (this document) (1)
Using the Wireless
Transmitter /
Receiver
1
Connect the supplied cables for
powered USB port and AC power
cords to their respective AC power
adaptors.
There are two AC power adaptors: one
for the transmitter and one for the
receiver. Connect the supplied cables for
powered USB port and AC power cords
to both AC power adaptors.
2
Connect the other ends of the cables
for powered USB port to the
transmitter and receiver respectively.
3
Check the transmitter and the receiver.
The mark "Transmitter" on the bottom
of this unit refers to the transmitter,
while the mark "Receiver" refers to the
receiver.
4
Connect the transmitter to HDMI
output equipment (such as a Blu-ray
Disc recorder, etc.), using an HDMI
cable (not supplied).
6
5
Connect the receiver to video
equipment (such as a projector, etc.),
using an HDMI cable (not supplied).
6
Connect the plugs of the AC power
cords to power outlets, then set the
respective power switches on the rear
panels of the transmitter and receiver
to on.
The LED lamp lights up (flashes) when
the unit is turned on and is operational.
You can check the status of this unit by
the LED lamp status.
LED lamp status
Lit (green)
Flashing (orange)
Lit (orange)
If the LED lamp continues to flash
orange after the power switch has
been pressed
Turn the power switch of the transmitter or
receiver off then on again, or press the reset
button until the LED lamp stops flashing and
turns off.
Notes
• Use an HDMI cable (not supplied) less than
3 m.
• The supplied cable for powered USB port
can only be used with the supplied AC power
adaptor. Do not connect it to the USB port of
a computer or other device. It may cause a
malfunction.
• Be sure to connect to target devices.
Connecting to other devices may cause
communication failure.
• Check precautions and instructions about the
usage location of the product. For details,
refer to the operating instructions of each
product.
Status of this unit
Power on
Searching for
connection
Connected