FILL DETERGENT TANK
NOTE: Use a non-foaming detergent with a pH
range between 7 and 11. Be sure to follow the
detergent instructions for proper dilution.
NOTE: Empty the recovery tank each time
detergent tank is filled.
1.
Fill detergent tank with water and/or detergent, if
desired. If using detergent, dilute according to
solution instructions. (See Figure 12)
2. Open flow from detergent tank by pushing
detergent tap lever up to horizontal position. Leave
open. (See Figure 13)
Figure 12
BEGIN WORK
1.
Lower squeegee by pushing squeegee release
handle down. Turn on unit and press brush button.
All lights will light up and unit is fully functional.
(See Figures 14 and 15)
Figure 14
PAGE 6 OF 36
OPERATION
Figure 13
Figure 15
2. Pull drive levers to begin work. (See Figure 16)
Figure 16
NOTE: The battery should be charged after
every use. For optimal battery life, leave
plugged in when not in use.
WHEN FINISHED CLEANING
1. Turn off machine by pressing the On/Off button
for at least four seconds.
2. Empty the recovery tank (see Maintenance).
3. Raise squeegee and wipe down blade with a
soft cloth.
4. Close the detergent tap.
5. Spin off brush (see Maintenance). Rinse.
6. Charge the battery (see Maintenance).
0521 IH-9424