Installation - THOMSON TG185n Manual Del Usuario

2

Installation

Introduction
In this chapter we will help you to:
1 Connect the cables.
2 Configure the THOMSON
Connect the cables
Proceed as follows:
1 Plug the connector of the electric power supply adapter into the power inlet port on the back panel of
your THOMSON TG185n.
2 Plug the adapter into a nearby mains socket.
3 Plug one end of the Ethernet cable into the Ethernet port of your THOMSON TG185n.
4 Plug the other end of the Ethernet cable in the Ethernet port on your computer.
Ethernet ports are often marked with the following label:
Configure the THOMSON TG185n
If you want to configure your THOMSON TG185n as:
Wireless Access Point, proceed with
page 8.
Wireless Repeater, proceed with
Wireless Client, proceed with
E-DOC-CTC-20080624-0009 v0.2
TG185n.
"3.1 Configuring The THOMSON TG185n As Access Point" on
"4 The THOMSON TG185n as Wireless Repeater" on page
"5 Your THOMSON TG185n as Wireless Client" on page
2 Installation
21.
29.
5