THOMSON TG185n Manual Del Usuario página 33

4 The THOMSON TG185n as Wireless Repeater
7 Click Apply.
8 The THOMSON TG185n prompts you that the configuration was successful.
Configure the IP settings of your THOMSON TG185n (optional)
If you still want to be able to access your THOMSON TG185n after connecting it to your access point, you
have to make sure that they are both using the same IP range.
If your access point is also a THOMSON product, this will automatically be the case and no extra
configuration is needed.
If you choose not to do this configuration or you don't know the IP settings of your Internet Gateway, you will
only be able to access the THOMSON TG185n by assigning a static IP address to your computer that is the
same range as your THOMSON TG185n.
To change the IP settings of your THOMSON TG185n:
1 On the Basic Setting menu, click Device IP Setting.
2 The Device IP Setting page appears. On this page you can configure the IP address of your THOMSON
TG185n. Select:
Assign static IP address to this device if you want to choose the IP address for your THOMSON
TG185n yourself.
Use the DHCP client protocol to automatically get the IP address for this device if you want your
access point to assign an IP address to your THOMSON TG185n. In this case you do not have to
provide an IP address, IP Subnet Mask and Gateway IP Address.
3 In the IP address box, type an IP address that is in the same range as your Internet Gateway.
4 In the IP Subnet Mask, type the same subnet mask as your Internet Gateway.
5 In the Gateway IP Address, type the type the IP address of your Internet Gateway.
6 Write down this IP address and subnet mask. From now on, you can only access the THOMSON TG185n
at this address.
7 You can now remove the Ethernet cable form your THOMSON TG185n and computer.
E-DOC-CTC-20080624-0009 v0.2
27