Configuring Wpa Encryption - THOMSON TG185n Manual Del Usuario

3 The THOMSON TG185n as Wireless Access Point
3.4.2

Configuring WPA Encryption

Configure the RADIUS server
Continuing from
Proceed as follows:
1 On the Advanced Setting menu, click RADIUS setting.
2 Under Primary Server, select Enable Primary Server.
3 In the Server IP address box, type the IP address of your RADIUS server.
4 In the Port Number box, type the RADIUS Port.
5 In the Shared Secret box, type the RADIUS Key.
Enable WPA
Proceed as follows:
1 On the Basic Setting menu, click Wireless Setting.
2 Clear the Enable WPS (Wi-Fi Protected Setup) check box.
3 In the Select Security Policy list, click the desired WPA version.
WPA2:
WPA2 is the most secure version, but not all wireless clients already support it. Before you select this
version, make sure that all of your wireless clients support it.
WPA-AUTO:
If not all of your wireless clients support WPA2 or if you are not sure if they support WPA2, we
recommend you to choose WPA-AUTO. Wireless clients that support WPA2 will use WPA2, the others
will use WPA.
WPA:
If none of your wireless clients support WPA2 choose this option.
To use WPA2-PSK on Windows XP Service Pack 2 (SP2) you first have to install Wi-Fi Protected
Access 2 (WPA2)/Wireless Provisioning Services Information Element (WPS IE) update or install
SP3 on your Windows XP.
You can find the WPS IE update on http://support.microsoft.com/kb/917021.
4 Click Apply to immediately apply your changes.
5 The THOMSON TG185n prompts you that the configuration was successful.
6 Configure your wireless client(s) with the same settings.
18
" Configuring the wireless encryption":
E-DOC-CTC-20080624-0009 v0.2