Honeywell HF Serie Manual De Instrucciones página 13

USE AND OPERATION (CONTINUED)
FUNCTION BUTTONS (CONTINUED)
TIMER CONTROL
The Timer is adjustable between 1 - 24 hours.
AUTO TURN OFF:
While unit is running, press the Timer button
flashing, press the
automatically.
AUTO TURN ON:
When unit is in a standby mode (plugged in with power light on), press the Timer button
and the display will flash. While the display is flashing, press the
of hours until you want the unit to turn ON automatically.
SLEEP MODE
When the Sleep Mode is activated in Air Conditioning mode, the set temperature will increase by 1°C
or 1°F after the first hour of cooling and will increase a further 1°C or 1°F after the second hour of
cooling. The unit will maintain this temperature for 5 hours. The set temperature will then reduce by
1°C or 1°F on the seventh hour and reduce a further 1°C or 1°F on the tenth hour. Sleep mode will
then deactivate automatically.
Note: The Sleep Mode can be deactivated during cooling mode by pressing any button at any time.
WATER FULL ALARM
Condensation may accumulate in the unit.
If the internal tank is full, error code "P1" will be displayed and an alarm will beep for 30 seconds.
The unit will not operate until the water has been drained from the lower drain plug (refer to Water
Condensation Drainage).
After switching the Local Air Conditioner off, the compressor will not start immediately. You must
wait about 4 minutes before it switches back on again.
or button to select the number of hours you want the unit to turn OFF
and the display will flash. While the display is
EN 9
or button to select the number