ABB System pro M Manual Del Usuario página 12

A. Permanent override:
Insert the key into the switch.
After 10 seconds the program contained in the key will be executed without
clearing the program contained in the time switch.
As soon as the key is removed the program of the time switch is again valid.
B. Copy (load) / Save (save):
The key makes it possible to save a program contained in the time switch.
It is also possible to copy the contents (program + settings Astro) of the key
into the clock.
1. Insert the key and wait for 2 sec.
2. Using menu, select the mode:
save : to save a program contained in the time switch,
load : to load the program of the key into the time switch,
: to check the program contained in the key.
3. Validate the selection with enter.
4. For save and load reconfirm with enter.
The following error messages may appear on the screen:
no prog : the key is empty, it does not contain any program.
Error : incompatible key type.
In these two cases:
Only the save mode is possible.
The error message remains on display as long as the key is present, but
in this case the program of the time switch is executed.
Override - waivers
TWA-1 : by pressing repeatedly on
TWA-2 : by pressing repeatedly on
channel C2.
If the state of the output is On:
st
1 pressure: temporary waiver. Off and
will let you return to the automatic mode.
nd
2 pressure: permanent override. On and
This overridemust be cancelled manually.
rd
3 pressure: temporary override 15 minutes. On,
The return to automatic mode will take place after 15 min.
- for channel C1
- for channel C1
flash. The next program step
are permanent.
10
and on + for
and 15 are permanent.