Sanitising Function - Teuco Hydroline Manual Del Usuario

SAnITISInG FUnCTIOn

SANITISING FUNCTION icon
GET OUT OF THE TUB icon
INSUFFICIENT SANITISER icon
INSUFFICIENT WATER icon
EMPTYING TUB icon
Teuco's sanitising function envisages the automatic
introduction of sanitising liquid into the bathtub,
after each time the product is used. The user need
only fill the dedicated tank periodically.
At the end of any of the water treatments (Whirlpool
or Sonic-massage), the bathtub sanitising screen
is displayed.
Activate the function
Sanitising starts by touching the related icon.
Sanitising is not carried out if you touch the
POWER icon.
Get out of the tub
For the first 30 seconds, the system waits for the
user to get out of the bathtub. The function exploits
the water already in the tub, so the latter will not be
emptied. The GET OUT OF THE TUB icon flashes
the entire time.
Start sanitising
The sanitising function starts by activating the
whirlpool for approximately 1 minute, during which
time the sanitising liquid is introduced automatically.
Wait
At the end of the whirlpool, the water and sanitising
liquid must remain in contact with the surfaces and
product components for 10 minutes. A timer counts
down the wait time.
EN
30"
10'
31