Maintenance; Cleaning All The Surfaces; Cleaning The Whirlpool Nozzles - Teuco Hydroline Manual Del Usuario

6. MAInTEnAnCE

CLEAnInG ALL ThE SURFACES

See the manual attached entitled CLEANING
INSTRUCTIONS.

CLEAnInG ThE WhIRLPOOL nOZZLES

1. hYDROLInE (DURALIGhT)
Remove the jet cover (1) using the purpose-
provided spanner supplied (see chapter entitled
"whirlpool jets").
Turn the jet nozzle (2) anti-clockwise and remove
all the parts it contains (3, 4).
Using the purpose-provided spanner (5), remove
the ring nut (6) and the ball (8).
Use limescale remover to clean and rinse with
water.
When repositioning the nozzle, make sure the seals
(2, 9) are correctly positioned in the dedicated seat
within the nozzle (10). To get the best operation
from the jet, refit the ring nut (6) without screwing
it on too tight.
2. hYDROLInE hYDROSILEnCE (hYDROSOnIC)
Remove the jet cover (5) using the purpose-
provided tool supplied then, use the dedicated
spanner (4) to disassemble the nozzle assembly
(3) and then remove its parts. Use limescale
remover to clean and rinse with water.
When repositioning the nozzle assembly (3), make
sure the seal (2) is correctly positioned in the
dedicated seat (1). To get the best operation from
the jet, refit the ring nut without screwing it on too
tight.
Reposition the cover (5) gently onto the jet,
making sure the plate snaps fully into place on
the centring pins.
In the event of a failure or malfunctioning
(e.g. Fault, replacement of pump, control
unit, power unit, etc.) please contact an
authorised Teuco Technical Service Centre.
The manufacturer will not be held liable for
damage caused by devices which have been
tampered with.
10
9
8
7
6
5
4
3
2
5
1
1
2
3
4
5
EN
OK NO
OK NO
35