Cleaning Instructions - DJO Aircast AirSelect Guia De Inicio Rapido

Tabla de contenido

Publicidad

3. Apply Brace
First, put on sock included with the brace.
• While seated, place foot in brace positioning the heel against the back of the
brace. Wrap foot flaps over the foot and the toe cover around toes (Figure 5).
• Replace front panel: Position front panel so the Aircast logo is over the toes
and the foot panel is situated inside the brace. The upper part of the panel
should be secured outside the brace (Figure 6).
• Secure straps from bottom to top (Figure 7). Tighten until snug and
comfortable.
4. Adjust Aircell Support
The Achilles Walking Brace aircells are initially deflated.
• Begin inflation on injured side first. Turn the SELECTOR found on the right-side
of the brace to the appropriate number (Figure 8). Number 1 inflates the aircell
on the right-side, Number 2 inflates the aircell on the left-side and Number 3
inflates the back aircell. The "lock" position should be used once all aircells are
inflated. This prevents accidental deflation.
• To inflate aircell, place finger over small hole on top of large inflation pump
found on the top right side of brace (Figure 9). Pump until aircell feels snug.
• To inflate other aircells, rotate SELECTOR to the appropriate number and then
press and release large inflation pump. Pump until aircell feels snug. When all
aircells are inflated, rotate SELECTOR to "lock" position.
• In the event of over-inflation, deflate aircells.
5. Deflate Aircells
To deflate aircells, turn the SELECTOR found on the right-side of the brace to the
proper aircell number (Figure 8).
• Press and hold finger on the small release button found on the top right-side
of brace (Figure 10).
• Deflate until pressure is comfortable.
Note: Deflate aircells before removing brace for proper fit when reapplying.
Note: Higher pressure provides more support when walking, lower pressure is more
comfortable when sitting or reclining. Pressure can also be adjusted by tightening or
loosening straps.
Note: The shell can be trimmed with a cast saw or cast scissors to accommodate
larger calves.
CLEANING INSTRUCTIONS: The foam liner and the heel wedges may be
hand-washed in 86°F/ 30°C water with mild detergent and air-dried. Do not put in
dryer or use other heat source to dry.
WARRANTY: DJO Global, LLC will repair or replace all or part of the unit and its
accessories for material or workmanship defects for a period of six months from the
date of sale.
MATERIAL COMPONENTS: Shell: Polypropylene. Front Panel: High Density
Polyethylene. Straps: Nylon. Lined Aircells (Anterior and Posterior): Polyurethane w/
Polyester Fabric. Inflation Pumps: TPU (Thermoplastic Polyurethane). Liner: Nylon/
Polyurethane/Polyester (Outer/Foam/Inner mesh). Binding: Polyester. Outer Sole /
Insole: EVA/Rubber. Selector Dial: Nylon. Sock (Achilles): Acrylic/Cotton. Heel
Wedges: Polyethylene/Polyester/Nonwoven Fabric Coating.
INTENDED FOR USE ON A SINGLE PATIENT.
NOT MADE WITH NATURAL RUBBER LATEX.
RX ONLY
NOTICE: WHILE EVERY EFFORT HAS BEEN MADE IN STATE-OF-THE-ART TECHNIQUES TO OBTAIN THE MAXIMUM COMPATIBILITY OF
FUNCTION, STRENGTH, DURABILITY AND COMFORT, THIS DEVICE IS ONLY ONE ELEMENT IN THE OVERALL TREATMENT PROGRAM
ADMINISTERED BY A MEDICAL PROFESSIONAL. THERE IS NO GUARANTEE THAT INJURY WILL BE PREVENTED THROUGH THE USE OF THIS
PRODUCT.
3

Publicidad

Tabla de contenido
loading

Tabla de contenido