Sharp LL-173C Manual De Funcionamiento página 20

MODE SELECT-1 Menu
Note:
- Depending on the resolution of the input signal,
even if menu options can be selected, the
display may not change.
OSD H-POSITION (OSD horizontal position)
The position of the OSD Menu can be moved to
the left and right. ( buttons)
OSD V-POSITION (OSD vertical position)
The position of the OSD Menu can be moved up
and down. ( buttons)
SCALING (Level of scaling)
The sharpness of the image can be adjusted.
( buttons)
Note:
- When an image area with a resolution smaller
than 1280 x 1024 pixels is selected, it is
enlarged to cover the whole screen (i.e. the side
ratio of the display may change).
LANGUAGE
You can choose the language used in the OSD
Menu.
1. After selecting [LANGUAGE], press the
The language selection menu will be displayed
on the screen.
2. Use the / MODE button to choose a language.
3. Press the MENU button.
Adjusting the screen display
button.
20
MODE SELECT-2 Menu
INFORMATION
A model name [MODEL], a serial no. [S/N], and
usage time [USAGE TIME] of the monitor can be
checked.
1. After selecting [INFORMATION], press the
button.
The product information will display.
2. Press the MENU button.
The product information will disappear.
Note:
- Please note that the indication of usage time at
purchase may not be 0 (zero), as a result of
factory inspection and other activities during
manufacture.
OFF TIMER
Power is automatically turned off when the set time
elapses.
1. After selecting [OFF TIMER], press the
2. Set [ON]/[OFF] by pressing the
If selecting [ON], press the
set the turn-off time by pressing the
(Between 1 and 23 hours may be set, by the
hour.)
3. Press the MENU button.
Notes:
- When [ON] is selected, the remaining time is
displayed in the upper right of the screen during
the last 5 minutes before the turn-off. (The
remaining time is displayed for approx. 5
seconds, on each minute.)
- During the last 5 minutes before the monitor
turns off, the remaining time is displayed. If the
power button is pressed during that time, the
shutdown time is reset to 1 hour. (The next time
the power is turned on, the shutdown time will
automatically reset to the time set in step 2
above.)
To turn the power off during this time, press the
power button twice.
- If the monitor is turned on when the [OFF TIMER]
is set to [ON], the set time appears on the display
for several seconds. (If there is no input signal,
[NO SIGNAL] is displayed.)
button.
buttons.
/ MODE button and
buttons.