Tabla de contenido
Publicidad
TS432U
Duplicator Mode User Guide
Operation
Loading hard drives
1. Plug in the power cord of the TS432U into a
power outlet.
2. Insert the SATA hard drive you want to copy
into slot marked "SOURCE DISK 4".
Align the SATA port on the hard drive with the
SATA connector in the drive bay slot
3. Insert the destination SATA Hard drives into
slots marked " TARGET DISK1" , " TARGET
DISK2 " or " TARGET DISK3". Align the SATA
port on the hard drive with the SATA connec
tor in the drive bay slot
Note:
Make sure the target hard drive has same or higher capacity than the source hard drive.
The duplicator process will not start if the target drive has a lower capacity.
Make sure TS432U is not connected to a PC through the USB or eSATA ports
4. Switch on the TS432U
5. Push the DOWN button to select the Duplicator Mode on the menu and press ENT to proceed.
Press ENT two more times to confirm to switch to Duplicator Mode.
The system will auto-detect the hard drives. After the drives have been detected, a screen similar to the one
below will be displayed:
Note:
Make sure the target hard drive has same or higher capacity than the source hard drive.
ENGLISH
TARGET DISK1
TARGET DISK2
TARGET DISK3
SOURCE DISK
UP
ENT
DOWN
ESC
18
Publicidad
Tabla de contenido
