SilverStone TS432U Serie Manual De Instrucciones página 20

TS432U
Duplicator Mode User Guide
Operation
Main menu: Copy HDD
The "Copy HDD" function will copy all the data form the source HDD to the target HDD.
TS432U will copy every block of capacity on the source HDD.
1. Load the source HDD and the target HDD into the TS432U. The system will auto-detect the hard drives.
After the drives have been detected, the following will be displayed:
2. Press ENT and "Copy HDD" will commence.
3. During the "Copy HDD" process the TS432U will display progress information
The amount of data remaining to be transferred (shown in gigabytes) and time will be displayed.
The progress information is refreshed every 15 to 20 seconds
4. Once duplication is complete, a job status screen will be displayed and the TS432U will beep
19
Note:
Make sure the target hard drive has
same or higher capacity than the
source hard drive.
Note:
When copy is complete, TS432U will
beep 5 times to indicate it is finished,
press ESC to stop the beep.
ENGLISH