Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Do not use alkyltate petrol as it consists of only 2% mixture and can damage the engine.
Use a suitable, clean container for mixing.
Shake the container with the oil well before opening and then mix oil and petrol
thoroughly.
Fuel and fuel mixtures age: Superimposed fuel and fuel mixtures can lead to starting
problems. Never store the same mixture in the tank for more than 30 days. Do not use a
petrol/oil mixture older than 90 days for the machine.
15.3.2 Filling up with Fuel
Always switch off the engine before refuelling. Never fill the machine with fuel
when the engine is running or while the engine is still hot – cool down time at least 2
minutes. Move more than 3 meters from the point of refuelling before restarting the
engine.
Fuelling procedure:
Unscrew fuel tank cap
o
Pour the oil-fuel mixture carefully into the tank
o
→ Do not spill anything!
Close the tank cap tightly.
o
→ Wipe up any spilled petrol!
16
OPERATION
16.1 Starting the Machine
16.1.1 Starting with Cold Engine
ZIPPER MASCHINEN GmbH
www.Zipper-Maschinen.at
ZI-BHS605
DANGER
1. Place the hedge trimmer on a flat,
stable surface.
2. Set the O
(O
).
N
3. Press fuel pump (B) 8 to 10 times.
4. Move the choke lever to start position
(C1).
5. Slowly pull out the start rope (D) until
you feel a slight resistance. Then pull
out the starting rope powerfully. Guide
the start rope back into the engine by
hand. Repeat up to 3 times until the
first ignition can be heard (engine
normally does not start here).
6. Move the choke lever (C) to the run
position (C2) = closed.
7. Pull the starting rope as described
(point 5) until the engine is running.
OPERATION
-O
switch (A) to position "I"
N
FF
21
Publicidad
Tabla de contenido
