Fender MUSTANG I Manual Del Proprietário página 3

MOD
DLY/REV
These "shared" LEDs indicate the position
MOD
These LEDs are numbered 1, 2, 3 and correspond to the three
positions within each of the selection ranges A, B, C, D on both
effects knobs. Use the LEDs to determine exactly which position
the knob is pointing to, for example, A 1 is shown below:
DLY/REV
Effect Selections
The tables below list the effect selections for each knob.
MODULATION EFFECTS
A1
Chorus
A2 Chorus Deep
A3 Flanger
B1
Touch Wah
B2 Bias/Sine Tremolo
B3
Optical/Vintage Tremolo Fast
MOD
C1
Vibratone Slow
C2 Vibratone Fast
C3
Pitch Shifter – Up a 5th
D1
Pitch Shifter – Down an Octave
D2 Phaser Medium
D3
Step Filter
DELAY EFFECTS
A1
Tape Delay 150ms / 1 Repeat
A2 Stereo Tape Delay 300ms / 3 Repeats
A3
Mono Delay 700ms / 4 Repeats
B1
B2
B3
MUSTANG
of whichever knob was turned last.
DLY/REV
MOD
DLY/REV
REVERB EFFECTS
Small Room Reverb
Plate Reverb
Large Hall Reverb
f e n d e r . c o m
I /I I ( V. 2 )
™
C1
C2
C3 Tape Delay
D1 Tape Delay
D2
Ducking Delay
D3 Echo Filter
♫
You can completely change the effects list on your
Mustang™ amplifier using Fender® FUSE™ software
available at https://fuse.fender.com.
Effects Level
You can adjust the effects level by holding down the EXIT
button while rotating either the MOD or DLY/REV knob,
depending on which effect type you want to adjust.
Tap Button
The TAP button can be used to "tap in" delay time and
modulation rate settings:
• Delay time — TAP button blinks
• Modulation rate — TAP button blinks
When you select a delay effect, the TAP button will blink
green in time with the delay time setting. When you select a
modulation effect, the TAP button will blink
the modulation rate setting.
When both delay and modulation effects are selected
simultaneously, the TAP button will blink
control the delay time setting.
♫
You can use TAP to set both delay time and modulation
rate by tapping in the modulation rate first, with NO
delay effect selected, then adding a delay effect and
tapping in the delay time last.
To set the TAP interval of effects:
1.
Select an effect that causes the TAP button to blink, using
the DLY/REV or MOD knob.
2.
Press the TAP button rhythmically (twice minimum) in time
with the desired interval.
Fender '65 Spring Reverb
Fender '63 Spring Reverb
Room
Large Hall
Small Hall
green:
red:
red in time with
green
and only
3