Far Tools GGC 3300 Traduccion Del Manual De Instrucciones Originale página 11

GENERATOR SET OVERLOAD
Never exceed the rated power capacity (Amperes and/or Watts) during continuous ope-
ration. Before connecting and running the generator set, calculate the electrical power
consumption of the electrical equipment (in Watts or Amperes). This electrical power (in
Watts and/or Amperes) is generally found on the identification plate of bulbs, electrical ap-
pliances, motors, etc. The total of all the powers of the equipment used should not exceed
at any one time the rated power of your generator set.
Note: an electrical appliance (compass saw, drill, etc.) consumes more Watts or Amperes
than the number specified on the identification plate when the motor is subjected to difficult
use. For example, a saw that is to cut an extremely hard material consumes 3 to 4 times
more Watts or Amperes than the number specified on its identification plate.
STARTING UP, OPERATING AND SHUTTING DOWN THE GENERATOR SET
Before making any attempt to start up the generator set, make sure that all the
instructions described in the above sections have been strictly adhered to
Starting up the generator set
a) Open the petrol cock by turning the handle (17) to «ON»
b) Close the starter by pushing the lever(18).
c) Set the on/off switch (13) to «ON».
d) Take hold of the start-up handle correctly.
e) Pull the start-up handle slowly until a slight resistance is felt and then return it slowly.
f) ake hold of the start-up handle correctly and pull the cord firmly and quickly (pull it com-
pletely and use both hands if required).
Return the handle slowly by hand. If the motor has not started, repeat the operation until
the motor has started by opening the starter progressively.
Check the condition of the rope. For your safety, if it shows signs of wear, closer to the
point of sale.
g) When the motor has started up, open the starter progressively.
118025-4-Manual-E.indd 28
© FAR GROUP EUROPE
EN
.
6/09/13 12:12:35