Ryobi RBV26B Manual De Utilización página 17

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 33
Deutsch (Übersetzung der originalen Anleitungen)
VACUUM HANDLE
This feature allows user to perform vacuuming duties
comfortably.
VACUUM TUBES
The vacuum tubes can be installed on the blower using a
cross-head screwdriver.
ASSEMBLY
PACKING LIST
Blower tube / Nozzle
Upper blower tube
Lower blower tube
Adaptor installed in vacuum bag
Upper vacuum tube
Lower vacuum tube
Lubricating oil
Operator's manual
Figure sheet
UNPACKING
This product requires assembly.
■ Carefully remove the product and any accessories
from the box. Make sure that all items listed in the
packing list are included.
WARNING:
Do not use this product if any parts on the Packing
List are already assembled to your product when
you unpack it. Parts on this list are not assembled
to the product by the manufacturer and require
customer installation. Use of a product that may
have been improperly assembled could result in
serious personal injury.
■ Inspect the product carefully to make sure no breakage
or damage occurred during shipping.
■ Do not discard the packing material until you have
care fully inspected and satisfactorily operated the
product.
ASSEMBLING THE BLOWER TUBES
See Figure 2.
■ Close the vacuum inlet cover securely. Make sure the
metal contact on the inlet cover is inserted into the
positive switch.
■ Align the raised tabs on the blower housing outlet to
the slots at the upper tube; slide and tighten securely
by twisting; press slider plate into the slot of the
positive switch to make sure the switch is engaged
and ready to operate.
English (Original instructions)
■ Connect the lower and upper tubes together.
■ Connect the nozzle.
■ To remove the blower tube, pull out the slider from the
INSTALLING THE VACUUM BAG
See Figure 3-4.
■ Unzip the vacuum bag and place the adaptor inside
■ Align the raised slots on the vacuum bag adaptor with
■ Rotate the vacuum bag until the shoulder strap is
■ Make sure the vacuum bag is zipped and closed
INSTALLING THE VACUUM TUBES
See Figure 5 - 6.
To install the vacuum tubes:
■ Secure the upper and lower vacuum tubes together
■ Depress door tab using a flathead screwdriver to open
■ Align tabs on housing with the tube assembly.
■ Tighten screws on the upper vacuum tube to secure
To remove the vacuum tubes:
■ Loosen screws of the upper vacuum tube by turning
■ Remove the vacuum tube assembly from the blower
15
15
positive switch, then rotate the tubes to remove them
from the blower housing outlet.
as shown. Push the vacuum bag adaptor through the
open ing in a direction opposite to the zipper. The wider
end of the adaptor will remain in the vacuum bag when
installed properly.
the raised locking tabs on the blower housing outlet;
push the bag adaptor onto the housing. Twist to lock
into place, press the metal contact into the positive
switch slot to make sure the switch is engaged and
ready to operate.
upright.
before starting the unit.
WARNING:
Rotating impeller blades can cause severe
injury. Always stop the engine and ensure
impeller blades have stopped rotating before
opening the vacuum door or installing/changing
tubes. Do not put hands or any other object into
the vacuum tubes while they are installed on the
unit.
by aligning the raised locking tabs with the matching
orifice on the upper vacuum tube. The two tubes
become one tube assembly after inserting them
together.
the vacuum inlet cover.
to the blower housing. Make sure the metal contact on
the vacuum tube is inserted into the positive switch.
counterclockwise.
housing.

Publicidad

Tabla de contenido
loading

Tabla de contenido