Gude GPS 40A Traducción Del Manual Original página 31

Seriennummer
Artikelnummer
Baujahr
Failure removal
Issue
Electric arc turned off
Welder suddenly stops working
after longer operation
Important information for the
customer
Please note that returns within or outside the warran-
ty period should always be in the original packaging.
This measure effectively avoids unnecessary transport
damage and any associated disputed ruling. Your
equipment is optimally protected only in the original
box, and keeping it in that box will ensure smooth
processing.
Causes
Poor contact between earth pliers
and the respective part
Short circuit between current nozzle
and gas supply pipe
Too loose current nozzle
Welder has overheated due to too
long use and the thermal protection
has activated
Removal
Tighten the pliers and check them
Remove paint and rust
Clean or replace the current and gas
nozzle
Current nozzle without dirt, paint and
rust remains
Tighten the current nozzle firmly
Let the welder cool down
ENGLISH
27