General Instructions - DeLonghi HMP Serie Manual De Instrucciones

Ocultar thumbs Ver también para HMP Serie:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

DESCRIPTION
A
Power selector
B
Pilot lamp
C
Thermostat
D
Wheel
FIRST USE

General instructions

Remove the heater from the packaging.
Check that neither the heater nor the power cable has been
damaged during transport.
Do not operate the heater if damaged. Remove all publicity
material present on the appliance. Your heater is suitable for
either freestanding or wall mounting usage. Do not assemble
the feet if wall mounting.
Electrical connection
-
Before plugging in the appliance, check that your supply
voltage is the same as that shown on the rating plate of
the appliance and that the power supply is able to with
stand the power consumption (Watts) shown on the
rating plate.
-
If using more than one appliance at a time, it is
important to ensure that the power supply is able to
with stand the power requirements.
Free standing operation
Mount the feet on the appliance using the screws provided:
4 x wing screws (E)
Fix the feet with the screws (E), as shown in fig.1.
CAUTION: Never use this heater without feet when not wall-
mounted.
Wall-Mounting Installation
The wall mounting kit contains:
1 x plastic support (F)
2 x 3.5x20 PH screws (G)
2 x 3.5x35 PH screws (H)
4 x 6x30 plastic anchors (I)
Required tools for assembly and estimated assembly
time
Screwdriver PH 2 x 100 (Phillips type)
Estimated assembly time: 30 minutes
Before installing the unit , make sure of the following:
The heater is not located directly below a power
-
outlet.
-
The power outlet can be easily reached by the
plug and after installation.
-
No electric cables or other pipes could be
damaged during the installation.
Keep away from curtains or inflammable
-
materials.
To wall-mount, proceed as follows:
For brick walls use a 15/64" (6 mm) concrete drill bit. For
plaster board or false (hollow) walls, it is recommended to
use appropriate screws and anchors (not supplied).
-
Before drilling the wall, mark the exact points,
respecting the minimum distances as shown in fig. 3
and fig. 4.
-
Drill the wall where previously marked, and insert the
plastic anchors (I).
-
Fix the support (F) using the two screws provided (H)
(see Fig. 4).
-
Hang the radiator on the support.
-
Mark out the 2 lower fixing points (fig. 2).
Remove the appliance, drill the lower holes and insert
the wall anchors.
-
Now, you can hang back the heater on the support and
fix the lower part of the appliance with the 2 remaining
screws (G).
USE
Functioning and use
-
Insert the plug into the mains.
-
Turn the thermostat knob in a clockwise direction until it
reaches the 6 setting.
Minimum power: turn the function knob to setting
-
"MIN" (the pilot light will light on).
-
Maximum power: turn the function knob to setting
"MAX" (the pilot light will light on).
Switching off: turn the function knob to setting "OFF"
-
and remove the plug.
Adjusting the thermostat
Turn the thermostat knob in a clockwise direction until
it reaches the maximum setting (6). When the room has
reached the desired temperature, slowly turn the thermostat
knob counter-clockwise until you hear a click and not
beyond. The thermostat will now adjust the set temperature
automatically keeping it constant.
Frost prevention mode
With the thermostat dial at minimum
mode selector on "MAX", the appliance maintains room
6
and the

Publicidad

Tabla de contenido
loading

Tabla de contenido