General Information; Wall Mounting - DeLonghi 279798 Manual De Instrucciones

1. SPECIFICATIONS OF THE APPLIANCE
Voltage: 230 V ~ 50 Hz
Insulation class: II
GB
Power Length
[W] [cm]
1000 65
1500 89
1800 105
Table 1
indicated on the rating plate on the side of the ra-
diator (Fig. 1).
A Brand/Manufacturer
B Model, type, category
C Bidimensional Code (QR)
D Protection class
E CE marking

2. GENERAL INFORMATION

Unpack the appliance carefully and rest it on the
polystyrene corner pieces or a carpet.
The package contains:
– the appliance
– remote control with two batteries and container
for wall mouting
– mounting kit
– instructions
Read all the instructions carefully before installation
and use. Keep for future consultation.
Install and use the appliance as described in these
instructions only.
These instructions do not cover all situations which
might arise. Caution and common sense should be
applied when installing, operating and servicing
the appliance.
Modifying the characteristics of the appliance and
is expressly prohibited. Make sure the appliance is
complete and undamaged. If damaged, do not use
the appliance, but contact your local dealer or a
The materials used for packaging can be recycled.
You are therefore recommended to dispose of them
in special differentiated waste collection containers.
Height Weight Rated current
[cm] [kg] [A]
59
59 20 6,5
59 25 8
F Double isolation
G Disposal procedures
H Quality marks
I Voltage and Power
L Serial number
3. POSITIONING AND INSTALLING
The appliance is designed to heat domestic rooms
or similar. It must not be used for other purposes.
The appliance must be used permanently mounted
on a wall as described in the instructions. Install the
appliance with the control panel at the top (Fig.2).
In bathrooms (with bath or shower), install the ap-
pliance outside zone 1.
The appliance must be installed in such a way that
the electronic controls and other control devices
may not be touched by someone in the bath or
shower. The appliance must not be connected with
a plug.
For radiators already fitted with power
plugs, see the warnings on page 24.
Never install the appliance:
– immediately below or in front of a power socket or
a junction box (Fig. 5)
–
–
or pressure vessels.
Make sure there are no pipes or electric wires in the
wall which could be damaged while mounting the
appliance.
The appliance is equipped with a sensor which can
detect an open window, if present above the radia-
tor or within the room. For a proper operation, it
is strongly recommended to comply to the instal-
mounting.

3.1 WALL MOUNTING

Make sure the screws and anchors included in the
mounting pack are suitable for the type of wall
on which you are mounting the appliance. If in
cal dealer.
Follow the installation sequence shown on the
folding leaf of the cover (Scheme 1), respecting the
minimum distance between the bottom of the ra-
During installation, make sure the power cable is
disconnected from the power line.
-