5
Install
on the wall using
WM1
suitable screws (not supplied)
and washers (not supplied).
× 2
8 mm × 60 mm
Note
Use a level to check whether
Precaution
Do not over-tighten wooden screw 8 mm × 60 mm.
Improper tightening could reduce the holding
power of wooden screw 8 mm × 60 mm.
6
Drill lower pilot holes on the
marks. (Refer step 4 for the drill
instruction.)
7
Fit the suitable screws and
washers to the holes.
Note
Use a level to check whether
8
Preparing for the Installation
of the TV or LCD Monitor
WM1
is level.
Note
Be sure to store the removed screws and unused parts
1
× 2
2
× 2
WM1
is level.
− 9 (GB) −
Pull out the arm of the bracket to
the end.
in a safe place, keeping them away from children.
Attach the Table-Top Stand to
make the TV or LCD Monitor
standing.
• Refer to your TV's or LCD Monitor's Setup
Guide.
Remove the screws from the rear
of the TV or LCD Monitor.
× 2
× 2
GB