Ryobi P922 Manual De Instrucciones

The lanyard snaps into the battery compartment of
most RYOBI ONE+
™
tools and provides a convenient method of storage
and transportation, as shown in Figures 1 and 2.
CAUTION:
Remove any blades, bits, or other sharp ob-
jects from the tool before attempting to store
or carry with the plug-in lanyard. Do not use
the lanyard with larger tools such as miter
saws. Use the lanyard only in RYOBI
brand tools. Do not exceed maximum holding
weight of 10 lbs.
1428 Pearman Dairy Road, Anderson, SC 29625 • Phone 1-800-525-2579
États-Unis, Téléphone 1-800-525-2579 • USA, Teléfono 1-800-525-2579
995000309
7-18-17 (REV:02)
TOOL LANYARD
P922
Fig. 1
18 volt portable hand-held
™
ONE+
™
ONE WORLD TECHNOLOGIES, INC.
Fig. 2
INSTALLING/REMOVING THE
LANYARD
See Figure 3.
To install:
n Remove the battery pack from the tool.
n Insert the lanyard stem into the tool's battery
compartment and press until the latches snap
into place.
To remove:
n Depress the latches on both sides of the lanyard
™
to release it from the tool.
Always mention the model number when
communicating with us regarding this product.
www.ryobitools.com
C
A - Battery compartment
B - Lanyard stem
C - Latches
A
B
C
Fig. 3