Rampage 68111 Manual De Instrucciones página 2

Installation
NOTE: Actual application may vary slightly from illustrations.
1
Remove existing soft top or hard top.
NOTE: The Rampage Complete Top for 1988-1995 Jeep Wranglers can only be installed
on vehicles with half doors.
2
Position Windshield Channel onto vehicle as
shown in Figure 1.
Once in position, secure Windshield Channel
using the included (11) - #8 x ¼" Sheet Metal
Screws.
NOTE: In some cases the holes on the
Windshield Channel will line up with existing
holes. In this case, ensure holes are not too
large to install the new screws included in the
package. If holes are to big, you must replace
the included screws with larger screws, found at
any local hardware store.
If you are replacing a hardtop, use the
Windshield Channel as a template to drill 1/8"
holes.
3
Windshield Upright Installation
Locate Driver Upper Door Windshield upright and position it on the side of the windshield. With Upper Door
Windshield upright in position mark the vehicle through the holes (See Figure 2).
Remove Upper Door Windshield upright and place aside. Carefully drill 1/8" holes on the marked locations.
Re-position Upper Door Windshield upright and secure it by using the included (4) - #8 x 1/2" Sheet Metal
Screws (See Figure 3).
Repeat steps 3-5 for opposite side.
Figure 2
Figure 1
Figure 3
Page 2 of 9