Rampage 68111 Manual De Instrucciones página 4

7
Lay Bow Assembly on a flat clean surface and
identify the Front and Rear Bow.
Note: The Front Bow will include foam padding
where as the rear will not.
Assemble the two halves of the Bow Assembly
using the included Connection Tubes with push
buttons. See Figure 9
Note: It may be helpful to use a flat screwdriver
to push down the buttons while sliding Bow
halves together. Also, it may be helpful for two
persons to slide both sides of the Bow Assem-
bly forward simultaneously.
8
With the Bow Assembly secured together, slide the
ends of the front and the rear bows into the tracks in
the Side Belt Rails on each side of the vehicle
See Figure 10 & 11
Note: Slide the Bow Assembly from the rear of the
vehicle towards the front. Secure Bow Ends by In-
serting Side Rail Pin into Side Rail
See Figure 11
9
Unfold Passenger Upper Side Rail towards the front
of the vehicle until it reaches the Passenger Upright
Pin.
Insert the plastic Upright's Pin through the Side Rail's
hole and lock it in place by sliding the square clip to
the opposite side See Figure 12 & 13
Note: Make sure the Upper Side Rail is properly
secure prior to installing the soft top. Damage to the
vehicle or personal injury can occur if not installed
properly.
Repeat this step for opposite side.
Figure 12
Figure 9
Connection Tubes
Figure 10
Figure 11
Figure 13
Page 4 of 9
Bow Assembly