Dehumidifi Er Mode; Night Mode; Setting The Timer - Listo CM7 L5 Manual De Utilización

• DEHUMIDIFIER MODE
Ideal for reducing the humidity in a room (spring and fall, damp rooms, rainy periods, etc.).
To select this mode:
• Press the MODE button until the "DRY" indicator light comes on. The display shows
In DEHUMIDIFIER mode, you cannot select the speed; the appliance adjusts it by itself.
O
SCILLATION OF THE FLAPS
This unit does not have the automatic fl ap oscillation function.
Adjust the ventilation fl aps on the front of the unit by hand.
A
A: horizontal oscillation
B: vertical oscillation
T
EMPERATURE UNIT SELECTION
Press the button on the remote control to select the temperature unit: either "°C" (degrees
Celsius) or "°F" (degrees Fahrenheit).
For example:
Before changing the unit, in AIR CONDITIONER mode, the screen displays the temperature in °C (fi g
1).
After changing the unit, in AIR CONDITIONER mode, the screen displays the temperature in °F (fi g 2).
V.1.0
.
B
34
N
IGHT MODE
This function is useful during the night as it gradually reduces the operation of the unit. When
you choose Night mode, the brightness and fan speed are reduced. Please not that Night mode
is not a silent mode.
To select this function:
• Select AIR CONDITIONING mode as described above.
• Press the button on the remote control.
The unit will operate in the previously selected mode.
The Night mode keeps the room at an optimal temperature without excessive fl uctuations in
temperature or humidity. The fan speed is always set to low while the temperature and humidity
of the room gradually change to ensure maximum comfort.
In AIR CONDITIONING mode, the selected temperature increases by 1°C (1°F) per hour over a
2-hour period. This new temperature is maintained for the next 6 hours. Then, the unit turns off .
NIGHT mode can be cancelled at any time during use by pressing the
control, MODE or .
In FAN or DEHUMIDIFIER mode, NIGHT mode cannot be selected.
S
ETTING THE TIMER
This timer can be used to delay the starting or stopping of the unit. This saves energy while
optimising the periods of use.
• Programming the start-up
• Turn on the unit.
• Choose the mode you want, such as AIR CONDITIONING mode at 24°C and high speed.
• Then turn off the unit.
• Press the button. The display shows 1-24 hours.
• Press repeatedly until the desired time is displayed. Wait about 5 seconds, and then the
timer will be activated, and the timer symbol will appear on the screen.
• To cancel the timer setting, press the button again. The
screen.
buttons on the remote
symbol will disappear from the
35 V.1.0