Technical Data - Macrom M2A.290 El Manual Del Propietario

• Two channel power amplifi er
• 90 watts into 2 ohms load
• 60 watts into 4 ohms load
• TO3P transistor on amplifi er stage
• Variable 18/12dB/oct Low-High-Band pass x-over
• Multiplayer x10 Frequency cutting
• Adjustable x-over from 30Hz to 600Hz (x1), 300Hz to 6000Hz (x10)
• Stereo/Mono mode selector (ST/mono Out)
• PWM Mos-Fet power supply
• High level Input (booster In)
• Mos-Fet power sup
RMS Power at 4 ohm Stereo load at 14,4 volts
RMS Power at 2 ohm Stereo load at 14,4 volts
RMS Power at 4 ohm Bridged load at 14,4 volts
THD (total Harmonic Distortion)
Frequency response (+0/-1 dB)
Signal to noise ratio
Low Input sensitivity
High Input sensitivity
Input impedance
Crossover type
Crossover frequency & fi lter slop (High-pass)
Crossover frequency & fi lter slop (Low-pass)
Dimension (w * h * d) mm
30 to 600Hz (x1) 300 to 6,000Hz (x10)
30 to 600Hz (x1) 300 to 6,000Hz (x10)
06
Features

Technical data

60 x 2 watts
90 x 2 watts
180 x 1 watts
< 0,1%
10 - 30,000Hz
> 95dB
200-8,000mV
1-10V
22k /100 ohm
Variable 18/12 dB/octave
225 x 50 x 190