Kinetico Water Systems K5 Manual De Instrucciones página 37

STEP 1 - Install Brass Tee Fitting
1
Turn off the cold water supply to
the sink.
2
Turn on the kitchen cold water faucet
to release pressure and allow water to
drain from the line.
U
P
4
Attach 1/4" white tube to the brass tee:
Slide compression nut onto the white
tubing (with threads of nut facing end
of the tube).
Next, slide the plastic sleeve onto the
tube. Place brass insert into opening of
the white tube.
Push tip of the white tube into
opening of the brass tee.
Slide the compression nut onto
the threads of the brass tee.
While holding the white tube in place
inside the brass tee, tighten compression
nut to compress plastic sleeve and create
a seal.
Do not connect the other end at this time.
Note: Use a wrench to ensure complete seal. Avoid over-tightening.
3
Disconnect the cold water line from
the threaded stem on the cold water
shut-off valve. Attach threaded ends
of supplied brass tee to the cold water
supply line and shut-off valve; tighten
using an adjustable wrench.
NEED HELP? GIVE US A CALL 877.333.7108
A
3