Kinetico Water Systems K5 Manual De Instrucciones página 38

INSTALLATION GUIDE
4
STEP 2 - Install System Manifold
1
Select an easily accessible area under
sink to mount System Manifold and
Remineralizer holder. Allow at least a
4-6" clearance to the floor below filters
to allow ample space for filter changes.
To help gauge the right location for
your System Manifold, insert First and
Third Stage filter sumps into manifold.
Insert sumps by aligning top connection
points and push up and to the right
until sumps are locked in.
2
Mark wall placement for mounting
screws using the built-in bracket on
back of manifold. Ensure holes are
level. Mark screw placement for the
Remineralizer holder 1-2" from the
Third Stage sump to the right of
the manifold.
3
Drill two pilot holes for mounting
brackets using 1/8" drill bit for the
System Manifold.
Note: Do not drill into anything
beyond the cabinet wall.
Note: Drilling holes into solid surfaces or surfaces made of stone should only
be performed by a qualified and certified installer.
NEED HELP? GIVE US A CALL 877.333.7108
REMINERALIZER
HOLDER
4
Insert anchors and mounting screws into
the wall leaving approximately 3/8" of
each screw exposed.
5
Remove First and Third filter sumps from
manifold by turning each sump to the
left and pulling down before hanging
manifold on wall. Mount manifold on
wall and screw in place.
Note: Avoid over-tightening.
6
Screw Remineralizer holder onto wall.