Hilti SF 4-A22 Manual Del Usuario página 18

4. Insert the battery. → page 11
5.6 Hilti Installing the retaining strap (optional)
ATTENTION
Damage to the product and / or the retaining leash. Incorrect handling
can result in damage to the product and/or retaining leash.
▶ Do not use a metal chain as a retaining leash. Do not use a retaining
leash with a length of more than 2,0 m (6 ft).
To avoid damage and injury, when working at a height it is advisable to
use the Hilti retaining strap.
The retaining strap allows a securing cord or lanyard to be attached.
When working with the product, you must comply with national regula-
tions for working at heights.
1. Remove the battery. → page 11
2. Insert the two tabs on the retaining strap into the slots on each side of
the base.
3. Secure the retaining strap with the screws supplied.
4. Insert the battery. → page 11
5.7 Fitting the accessory tool
1. Open the keyless chuck.
2. Insert the accessory tool into the chuck.
3. Tighten the keyless chuck.
4. Check that the accessory tool is held securely.
5.8 Selecting the gear
The gear selector switch can be operated only when the motor is not
running.
▶ Select the gear.
5.9 Setting the torque
▶ Set the desired torque.
The torque is limited only when the power tool is set to screwdriving
mode .
12 English
5
6
7
4
2253606
*2253606*