Jig Saw Safety Warnings; Mains Connection - Gude STS 800-2 EL Traducción Del Manual De Instrucciones Original

ENGLISH
16
Class II tool.
~
AC Current
CE marking
Any damaged or disposed electric or
electronic devices must be delivered to
appropriate collection centres.
WARNING Read all safety warnings, instruc-
tions, illustrations and specifications provided
with this power tool. Failure to follow the warnings
and instructions may result in electric shock, fire and/
or serious injury.
Save all warnings and instructions for future
reference.

Jig saw safety warnings

Hold the power tool by insulated gripping sur-
faces only, when performing an operation where
the cutting accessory may contact hidden wiring
or its own cord. Cutting accessory contacting a „live"
wire may make exposed metal parts of the power tool
„live" and could give the operator an electric shock.
Use clamps or another practical way to secure
and support the workpiece to a stable platform.
Holding the work by hand or against your body leaves
it unstable and may lead to loss of control.
Additional Safety and Working
Instructions
Use protective equipment. Always wear safety
glasses when working with the machine. The use of
protective clothing is recommended, such as dust
mask, protective gloves, sturdy non-slip footwear and
ear defenders.
The dust produced when using this tool may be
harmful to health. Do not inhale the dust. Use a dust
absorption system and wear a suitable dust protec-
tion mask. Remove deposited dust thoroughly, e.g.
with a vacuum cleaner.
Clamp your workpiece with a clamping device.
Unclamped workpieces can cause severe injury and
damage.
Always keep the connection cable from the working
area of the device. Always guide the cable backwards,
away from the device!
Do not machine any materials that present a danger
to health (e.g. asbestos).
This product corresponds to
the laser class 2 in accordance
with EN 60825-1:2014
P≤ 1 mW / λ = 650nm
Do not stare into beam.
When working in walls ceiling, or floor, take care to
avoid electric cables and gas or waterpipes.
Do not use cracked or distorted saw blades.
Do not reach into the machine while it is running.
Chips and splinters must not be removed while the
machine is running.
WARNING! Danger of burns
The insertion tool may become hot during use.
Do not let any metal parts reach the airing slots -
danger of short circuit!

Mains Connection

Operation is only allowed with a safety
switch against stray current (RCD max. stray
current of 30mA).
Connect only to single-phase AC system voltage as
indicated on the rating plate. It is also possible to
connect to sockets without an earthing contact as
the design conforms to safety class II.
Only plug-in when machine is switched off.
Laser
Do not stare into beam. Do not point laser light at
other persons.
Do not view directly into beam with optical instru-
ments (binocular, telescope).
Do not point laser at reflective surfaces.
Avoid exposure to laser radiation. Laser may emit
hazardous radiation.
Do not replace the installed laser with a different
type.
Any repairs must only be carried out by the autho-
rized service agent.
Maintenance
Unplug the machine before any work on it.
Repairs and works specified in these Instructions may
only be performed by qualified authorised staff.
Use only original accessories and original spare parts.
Keep the device, in particular the air vents, clean at all
times. Never spray water on the device body!
Do not clean the plastics with solvents, flammable or
toxic fluids. For cleaning, use a damp cloth only.
Caution! If the power cord of the appliance gets
damaged, it must be replaced by the manufacturer or
its customer service or a similarly qualified person to
avoid danger.
Only a regularly maintained and treated appliance
can serve as a satisfactory aid. Insufficient mainte-
nance and care can lead to unforeseen accidents and
injuries.
If necessary, a list of spare parts can be found at www.
guede.com.