WeatherTech 110127 Instrucciones De Instalación

MudFlaps
1 1
Thoroughly wash your vehicle, removing all dirt, debris
and stains from each fender in the areas where the
MudFlaps will be installed.
2 2
Park the vehicle on level ground. Begin with the driver's
side MudFlap installation.
3 3
Locate the (2) two factory Phillips head screws at the inner
fender and (1) one factory plastic fastener at the underside of
the fender as indicated.
5 5
Using the MudFlap marked "LH," place it up to the fender and
align with the corresponding holes.
View: Underside of fender
Installation Instructions
4 4
Using a ratchet, appropriate socket and supplied Phillips bit,
remove the (2) two factory Phillips head screws at the inner
fender. They will be reused. Then, remove the (1) one factory
plastic fastener at the underside of the fender with a trim clip
remover. Pull the head of it up and then the base out of the
fender. This will not be reused.
6 6
View: Underside of fender
Re-install the (2) two previously removed factory Phillips head
screws at the inner fender through the holes in the MudFlap
with the ratchet, appropriate socket and supplied Phillips bit
and tighten to a snug fit. Then, take (1) one supplied plastic
fastener and fully install it at the underside of the fender.
What You Need
48MF569 Parts Kit:
(1) Phillips Bit
48MF550 Parts Kit:
(2) Plastic Fasteners
Ratchet and Socket Set*
Trim Clip Remover*
*Not included
View: Underside of fender