Teka XT1 891 W Montaje Y Modo De Empleo página 8

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 15
spigot of Ø 100/125 mm).
Drill the holes for fixing the hood with a Ø 5 mm drill-bit.
Lean the unit against the top part of the cooker hood and
tighten it up to the hood with the 4 self-threading screws.
Maintenance
Cleaning
Clean using ONLY the cloth dampened with neutral liquid
detergent.
DO
NOT
INSTRUMENTS. Do not use abrasive products. DO NOT USE
ALCOHOL!
Grease filter
Traps cooking grease particles.
If situated inside the support grill, it may be one of the
following types:
Paper filter must be replaced once a month or if colouring
appears on upper side, in such cases the colouring is evident
through the grill openings.
Metallic filter must be cleaned once a month, with non
abrasive detergents,
by hand or in dishwasher on low
temperature and short cycle.
When washed in a dishwasher, the grease filter may discolour
slightly, but this does not affect its filtering capacity.
To access filter, open the suction grill with hooks and free it
from the stops.
Charcoal filter (filter version only)
It absorbs unpleasant odors caused by cooking.
The saturation of the charcoal filter occurs after more or less
prolonged use, depending on the type of cooking and the
regularity of cleaning of the grease filter.
In any case it is necessary to replace the cartridge at least
every four mounths (or when the filter saturation indication
system – if envisaged on the model in possession – indicates
this necessity).The charcoal filter may NOT be washed or
regenerated.
Remove the grill.
Apply the carbon filter to cover the grill that protects the
suction motor and turn the carbon filter clockwise to block it
(bayonet fixed).
Put the grill back.
Reverse dismantling.
CLEAN
WITH
TOOLS
Replacing lamps
Disconnect the appliance from the electricity.
Warning! Prior to touching the light bulbs ensure they are
cooled down.
Replace the old light bulb with the one of the same type as
specified in the feature label or near the light lamp on the
hood.
Changed the damaged bulb using exclusively 40W max (E14)
OR
olive bulbs.
If the lights do not work, make sure that the lamps are fitted
properly into their housings before you call for technical
assistance.
8

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Xt1 892 w

Tabla de contenido