Product Description - GYS NOMAD POWER VAC 350 Manual De Instrucciones

Translation of the original instructions

PRODUCT DESCRIPTION

Thanks to its high-performance lithium-ion battery, the NOMAD POWER VAC 350 performs 3 functions:
• Instant start of vehicles equipped with a 12V battery (6 cells of 2V), such as Go-karts, motorcycles, cars, vans, etc.
• Hand-held vacuum cleaner with a suction power (vacuum) greater than 4700 Pa.
• Power supply via its USB port (5 V - 2 A). Most mobile phones, smart phones, portable gaming devices, MP3/MP4
players can be charged with the supplied USB C-type cable.
NOMAD POWER 350 VAC
Extreme outside temperatures or mechanical problems on the vehicle (poor starter, no fuel or engine pro-
blems) can limit the booster's capacity.
INTERNAL BATTERY CHARGING
（adapter not included）
USE AS A BOOSTER
Emergency start function for petrol or diesel vehicles equipped with a 12 V battery.
To start a vehicle, proceed as follows:
1
2
3
4
"Forced start" button
5
10
NOMAD POWER VAC 350
Start function
       
1 - Plug the USB cable (12) to a charger with a USB output (not supplied)
2 - Plug the USB-C
POWER start the charge.
The NOMAD POWER must be at least 50% charged to make a start attempt. A full charge
of the booster is recommended.
Press the On/Off button (1) for a long time (> 3 s) to find out the charge status of your booster thanks
to the charge indicators (3).
Connect the smart start cable (9) to the connector (6) of the NOMAD POWER.
The red and green LEDs (10) flash alternately.
1- Connect the red clamp to the (+) of the battery.
2- Connect the black clamp as far as possible from a fuel hose or fitting and as close as
possible to the starter ground.
The power relay opens and closes while waiting to start-up. A sound is audible at every
opening and closing.
Start the vehicle
- If the vehicle does not start, wait 30 seconds between each start attempt.
- If the vehicle does not start after two attempts, the «forced start» function can be used.
Press and hold the button (11), located on top of the smart start cable, for 3 seconds to
initiate a forced start.
The light on the starter cable turns steady green. Perform a start up within 30 seconds.
end of the cable to the input port (4) of the NOMAD
EN