Progress Lighting AirPro P250003 Manual De Instalación página 9

Installing Fan to
the Electrical Box
WHEN USING THE STANDARD BALL/DOWNROD
MOUNTING, THE TAB IN THE RING AT THE
BOTTOM OF THE MOUNTING BRACKET MUST
REST IN THE GROOVE OF THE HANGER BALL.
FAILURE TO PROPERLY SEAT THE TAB IN THE
GROOVE COULD CAUSE DAMAGE TO WIRING.
1. Pass the 120-volt supply wires through the
center hole in the ceiling mounting bracket
as shown in Figure 11.
2. Install the ceiling mounting bracket on the
electrical box by using the mounting screws
provided with the electrical box. Note that
the flat side of the mounting bracket is
toward the electrical box. (Figure 11)
3. Tighten the two screws on the electrical box
securely.
4. Carefully lift the fan assembly up to the
ceiling mounting bracket. Make sure the tab
on the mounting bracket is properly seated
in the groove in the hanger ball. (Figure 12)
UL Listed
Electrical
Box
Ceiling
Mounting
Bracket
Hook
120V Wires
Standard mounting
Connecting the Safety
Cable
1. Turn the wood screw (LL)(not provided)
into the ceiling.
2. Place the looped end of the safety cable (S)
onto the wood screw and then tighten the
Washers screw firmly, or connect the safety cable
directly to the electrical box. (Figure 13)
Mounting
Screws
(Supplied with
Electrical Box)
LL
Figure 11
S
Figure 12
Figure 13
6.