Publicidad
T-Connector Wiring Kit
INSTALLATION INSTRUCTIONS
1. Read instructions thoroughly before beginning.
2. Locate the vehicles factory OEM trailer light wiring harness.
On vehicles equipped with a factory 7-way connector, the harness
will be attached to the hitch on the left (driver's) side at the rear of
the vehicle (fig. 1). For vehicles without factory tow wiring
connectors, the harness will be
located under the vehicle along
the left (driver's) side frame rail
near a cross member (fig. 2).
The harness will have a connector
similar to that on the end of the T-
Connector.
For Vehicles With an OEM
Factory 7-Way Connector:
3. Separate the 7-Way connector
from the vehicle wiring harness.
Carefully remove the grey locking
tab (fig. 3A) and gently pull the connector
and harness apart while holding down on the connector locking
latch (fig. 3B) taking care not to damage the locking tabs.
4. Position the T-Connector ends between
the vehicle harness and the 7-Way
Connector. Insert the long T-Connector
socket into the factory harness connector.
Firmly press the ends together until the
locking tabs engage. Insert the 7-Way
B
A
Fig 1
Fig. 2
Fig. 3
Publicidad
