Switching The Player On And Off - Dune HD Duo 4K Manual De Instrucciones

ENGLISH
UPnP protocols, use "Network Browser" item in "Sources" section of the player
menu.
NOTE: If some network resources are not shown by the player, you may need
to wait some minutes and then retry (or press the "POP UP MENU" RC button
and choose "Refresh" command).

Switching the Player On and Off

To switch the player on and to switch it off completely, use the power switch on
the rear panel of the player.
To put the player into the standby mode, press the "POWER" RC button or the
"on/off" button on the front panel. To exit the standby mode, press any of these
buttons again.
Depending on the player settings (see the player setup menu), the «hardware
standby» or «software standby» mode may be used.
In the «hardware standby» mode, almost complete power-off takes place and
the player consumes almost no power.
In the «software standby» mode, the player produces no signal on the video
output, but is still functioning. For example, if you have some storage devices
connected to the player, you may still access them from network («NAS»
function of the player). Exiting the «software standby» mode takes just a few
seconds. When the player is in the «software standby» mode, it still consumes
significant power. It is not recommended to keep the player in the «software
standby» mode for a while if you do not need it.
NOTE: After switching the player off completely or putting the player into the
«hardware standby» mode, it is recommended to wait about 1 minute before
switching it on again.
13