Philips HR 4325/00 Manual De Instrucciones página 10

Automatic overheating safety device
To prevent damage and reduce safety risks the overheating
safety device switches off the fan motor if it becomes too hot.
To indicate that the appliance is still in switched-on position
and connected to the mains,
the indication light will remain
on.
If this happens:
- Switch the appliance off
(fig. 51).
(The indication light goes
out.)
- Remove the mains plug
from the wall socket.
- Wait for the motor to cool
down (approx. 15 minutes).
52
- Remove the front cover (fig. 52).
Check that the filters are not blocked and that nothing is
obstructing the airflow.
- Check that the Rota filter can rotate freely if moved by hand
(fig. 53).
- Close the appliance. Put the mains plug back into the wall
socket and switch the appliance on.
If the automatic overheating device is activated repeatedly, it is
advisable to take the appliance to your dealer for technical
inspection.
51
53
Fitting a different plug
This appliance is fitted with a BS 1363 13 Amp. plug.
Should you need to replace the plug, connect the wires as
follows:
Brown wire to the Live (L) terminal of the new plug.
Blue wire to the Neutral (N) terminal of the new plug.
Always fit the same value of fuse as that originally
supplied with your appliance.
Only use BS 1362 approved fuses.
As a guide only: Appliances under 700 W can have a 3
Amp. fuse (red) and all others should have a 13 Amp. fuse
(brown).
When disposing of an old plug (particularly the moulded
type which has been cut from the mains cord) always
remove the fuse as the plug could be dangerous if ever
inserted in a live socket.
10
For U.K. only: