Snap-On ET 1460 Manual Del Usuario página 11

should be regularly inspected for wear. To inspect brushes, unscrew
the plastic brush inspection caps (located in the sides of the motor
housing) and the spring and brush assemblies may be withdrawn
from the tool. Keep brushes clean and sliding freely in their guides.
Carbon brushes have varying symbols stamped into them, and if the
brush is worn down to the line closest to the spring, they must be
replaced. New brush assemblies are available at service centers; see
"Tool, Electric" in the yellow pages.
If you need assistance in locating any accessory, please contact
Snap-on Tools Corporation, Kenosha, WI 53141-1410.
CAUTION: The use of any non-recommended accessory may be
hazardous.
Important
To assure product SAFETY and RELIABILITY, repairs, maintenance
and adjustment (including brush inspection and replacement) should
be performed by authorized service centers or other qualified service
organizations, always using identical replacement parts.
Full Warranty
Snap-on heavy duty industrial tools are warranted for one year from
date of purchase. We will repair, without charge, any defects due to
faulty materials or workmanship. This warranty does not apply to
accessories or damage caused where repairs have been made or
attempted by others. This warranty gives you specific legal rights and
you may have other rights which vary in certain states or provinces.
In addition to the warranty, Snap-on tools are covered by our:
30 DAY NO RISK SATISFACTION GUARANTEE
If you are not completely satisfied with the performance of your Snap-
on heavy duty industrial tool, simply return it to the participating seller
within 30 days for a full refund. Please return the complete unit,
transportation prepaid. Proof of purchase may be required.
7