Snap-On ET 1460 Manual Del Usuario página 9

FIG. 6 FIG. 7 FIG. 9
INSTALLING
NOTE: If you are using a polishing bonnet, rather than a pad, put
clamp washer on first, pull bonnet completely over backing pad and
pull draw strings tight Tie bow knot and push knot and all loose string
BACKING PAD
SPINDLE LOCK
BUTTON completely under the inside, cloth edge of the polishing bonnet.
WARNING: TIED KNOT AND ALL STRINGS MUST BE TUCKED
ENTIRELY UNDER THE CLOTH APRON. FAILURE TO DO SO
FIG. 8
MAY CAUSE SERIOUS INJURY.
REMOVING
Polishing
PHENOLIC DISC
These instructions and suggestions are intended to familiarize new
operators in overall general operation of power polishing. You will
develop your own techniques which will make the job easier and
faster as you learn power polishing.
You should use utmost care when power polishing around or over
sharp objects and contours of the car body. It is very important to use
SANDING DISC
the correct pressure while polishing various sections of an
automobile body. For example, light pressure should be applied
when polishing over sharp edges of body panels, or over edges of
CLAMP WASHER
the rain gutter along the top.
SPINDLE LOCK
Since everyone does not use the same type of power polish, we
BUTTON
5