Auxiliary Handle - Snap-On ET 1460 Manual Del Usuario

Additional Safety Instructions
for Sanders
• ALWAYS WEAR EYE PROTECTION.
• Clean your tool out periodically.
CAUTION: Wear appropriate personal hearing protection during
use. Under some conditions and duration of use, noise from this
product may contribute to hearing loss.
WARNING: Some dust created by power sanding, sawing, grinding,
drilling, and other construction activities contains chemicals known to
cause cancer, birth defects or other reproductive harm. Some
examples of these chemicals are:
• lead from lead-based paints,
• crystalline silica from bricks and cement and other masonry
products, and
• arsenic and chromium from chemically-treated lumber (CCA).
Your risk from these exposures varies, depending on how often you do
this type of work. To reduce your exposure to these chemicals: work in
a well ventilated area, and work with approved safety equipment, such
as those dust masks that are specially designed to filter out
microscopic particles.
• Avoid prolonged contact with dust from power sanding,
sawing, grinding, drilling, and other construction activities.
Wear protective clothing and wash exposed areas with soap
and water. Allowing dust to get into your mouth, eyes, or lay on the
skin may promote absorption of harmful chemicals.
SAVE THESE INSTRUCTIONS

Auxiliary Handle

An auxiliary handle is furnished with your tool and can be installed on
either side of the front housing. This handle should be used at all
FIG. 1
SPINDLE LOCK BUTTON
times to maintain complete control of the tool.
Single Speed Switch (ET1460 ONLY)
These tools are equipped with a single speed on-off switch. To turn
the tool on, squeeze the trigger switch shown in Figure 2. To turn the
tool off, release the trigger switch.
The tool can be locked on for continuous use by squeezing the
trigger switch fully and depressing the lock button shown in Figure 2.
Hold the lock button in as you gently release the trigger switch. The
tool will continue to run. To turn the tool off from a locked on position,
squeeze and release the trigger switch once. Do not unplug the tool
with the switch in the locked on condition. Make sure the tool is not
locked on when plugging in. A locked on tool will start immediately
when plugged in.
2
AUXILIARY HANDLE
can be installed on either
side of housing