Publicidad
Idiomas disponibles
Idiomas disponibles
4. Position two remaining panels with the hooks (A)
facing the slots (B) on the outside edge of the corner
wall panels. (See Figure 8)
5. Lift panel and slide hooks (A) down into slots (B).
NOTE: Make sure both pair of interlocking
brackets are connected – at the top and
bottom of each panel.
Figure 8
6. Insert the aluminum brackets in the middle channel
of each panel. Brackets should be placed in the
center of each panel and in the outermost part of
the outside panels inset approximately two inches to
not interfere with desk frame. (See Figure 9)
Figure 9
Aluminum
Bracket
PAGE 4 OF 21
PANEL ASSEMBLY CONTINUED
Clip B
7.
Position the L-Desk inside the connected panels and
move the L-Desk to be flush with the panels. As the
L-Desk is moved flush with the panels, the aluminum
brackets will slide between the small opening in the
desk top and frame. (See Figure 10)
Figure 10
Clip A
8. Attach aluminum bracket to underside of desk top
using a drill and two M4 x 16 mm screws. Repeat for
remaining aluminum brackets. (See Figure 11)
NOTE: The desk top does not have pre-drilled
holes. The screws should be drilled directly into
the desk top.
Figure 11
M4 x 16 mm
Screw
0321 IH-9207
Publicidad
