1-Person L-Desk kit is now fully assembled. If assembling
a 2-Person L-Desk kit, proceed to step 9.
9. For 2-Person L-Desk kit assembly, prepare second
L-Desk and additional panels for attachment. For
second L-Desk, repeat Desk Assembly steps.
10. To attach additional panels to the completed L-Desk,
the aluminum trim will need to be removed from
the universal connector post. First, use a flat head
screwdriver to gently pry off trim cover piece on the
top. (See Figure 12)
Figure 12
Outside
Corner
View
PAGE 5 OF 21
PANEL ASSEMBLY CONTINUED
Completed
Assembly
Trim Cover
11. Starting from the top, use a flat head screwdriver
to gently pry the aluminum trim apart from the
universal connector post. This will expose another
side of the universal connector post to connect
additional panels. (See Figure 13)
Figure 13
Universal
Connector
Post
12. Attach clip B to the top pre-drilled holes in the
universal connector post using two M4 x 20 mm
screws. Repeat for the bottom pre-drilled holes.
(See Figures 14-15)
Figure 14
Aluminum
Trim
Clip B
M4 x 20 mm
Screw
0321 IH-9207