How To Clean; Regular Cleaning - Hamilton Beach 54614 Manual De Instrucciones

How to Clean

Quick Cleaning
Quick cleaning should only be used
to rinse the blender between batches
of processing the same food. When
the processing of a single type of
food is finished, the blender should be
disassembled and thoroughly cleaned
as instructed below.
To quick clean, pour 2 cups (500 ml)
warm water in jar and add 1 drop liquid
dishwashing detergent. Run the blender
on DISPENSE for 10 seconds. Flush
soapy water through dispenser until
cleaned. Discard soapy water. Rinse

Regular Cleaning

Electrical Shock Hazard.
w WARNING
Disconnect power before cleaning.
Do not immerse cord, plug or base in any liquid.
1. Unplug blender from electrical outlet.
2. Wipe blender base and cord with a
damp cloth or sponge. To remove
stubborn spots, use a mild, non-
abrasive cleanser.
3. To clean jar, unscrew cutting
assembly from jar.
4. Carefully remove gasket from
cutting assembly.
5. Remove dispenser assembly from
NOTE: DO NOT remove seal rings
from dispenser adapter.
6
840155505 ENv01.indd 6 840155505 ENv01.indd 6
blender jar with clean water. Flush clean
water through dispenser until cleaned.
This function is not a substitute for
regular cleaning as instructed below
This function should never be used
when blending any mixture containing
eggs, milk, or any other dairy products.
6. Carefully wash cutting assembly,
gasket, jar, and lid in hot, soapy
water. Rinse and dry thoroughly.
Do not soak. Do not wash cutting
assembly or gasket in a dishwasher.
NOTE: All parts except the cutting
assembly and gasket may be
washed in the dishwasher (on the
top rack only). Some part distortion
may occur if your household
dishwasher temperature is higher
jar by turning
than normal or if the parts are placed
counter-
too close to the heating element.
clockwise four
7. Reassemble cutting assembly and
revolutions.
gasket onto jar, and replace jar onto
blender base. Ensure dispenser
assembly or spout cap are fully
rotated clockwise to lock into
position (reverse of Step 5 above).
8. Store blender with lid or filler cap
removed to prevent container odor.
7/19/12 1:13 PM 7/19/12 1:13 PM