Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
English
General Instructions
No modifications or alterations can be made to the product without authorisation from the manufacturer, in the
event of this, the guarantee will be invalidated.
National standards and safety regulations must be observed.
Safety instructions
Before the product is used, it is to be checked for correct functioning. Should any defects appear, it must not be
used!
Only use for the intended purpose!
The table must not be moved in a raised position!
The bearing capacity given must not be exceeded
Use and intended purpose
The lifting table is a device for lifting loads that are preferably on pallets or in mesh box pallets. It can be moved for
short distances on an even surface. The height is adjusted by means of a hydraulic foot pump and this allows a
rapid and optimum adjustment of working height.
The operational temperature range is from -10°C to 40°C.
Specifications
See type label.
Operation
Loading
When loading the table, care is to be taken that the load is evenly distributed over the table surface (on approx.
80% of the table area).
Brake function
The brakes are provided with a locking device on the right side.
-
To brake press the locking device.
-
To release the brake lift the locking device.
Raising the table
Before the table is raised the brake must be locked.
Activate the lifting pedal (3) several times until the table has reached the desired height.
The table cannot be raised further when it has reached its maximum height even if the pedal is further activated.
The hydraulic cylinder now holds the table at the desired height.
Lowering the table
Before you start lowering the lifting table you must make sure that the scissor area is clear.
All the time the lowering lever (2) is being pulled, the table will sink slowly down.
Hubtischwagen 157623 / 157624 /
157625 / 157627
157628 / 157629
Seite 7 von 16 Seiten
brake
on
off
Release brake
Ausgabe10/2007
Publicidad
Tabla de contenido
