Moser 4437 Instrucciones De Uso página 9

Description of parts (Fig. 1)
A Cool tip
B Conic heating element
C Base stand
D LCD display
E On/off switch
F Button to increase temperature
G Button to reduce temperature
H Handle
I
Mains cable with anti-twist device
Operation
· Unfold the base stand and place the appliance on a
flat, smooth, non-heat-sensitive surface.
· Connect to the mains power supply.
· Using the on/off switch (E), switch on the appliance
(Fig. 2).
· Set the desired temperature (80°C – 210°C).
The preset temperature is 180°C.
To increase the temperature, press the p button
(F).
To reduce the temperature, press the q button (G).
Note: The temperature can be adjusted by 5°C at a
time by tapping on either of these buttons. To adjust
the temperature more quickly, hold down the appro-
priate button.
· The LCD display flashes three times when the tem-
perature is set. Once the set operating temperature
has been reached, the LCD display shows the tem-
perature. The LCD display flashes until the desired
temperature has been reached. After the desired
temperature has been reached, the flashing stops.
· After use, switch off the appliance with the on/off
switch (Fig. 2). Hold the on/off switch to do this. The
LCD display must go out.
· Disconnect from the mains power supply.
· Allow the appliance to cool down.
· For safety reasons, the appliance switches itself off
automatically after 60 minutes. For continued use,
the appliance will need to be switched on again
(Fig. 2).
TITANIUM, CERAMIC and TOURMALINE
(depending on model)
Negative ions have an antistatic effect and are gen-
tle to the hair. They close the scale layer, creating a
smooth, silky hair surface and lock in the natural mois-
ture of the hair, thereby creating the ultimate shine.
Tips for successful styling
Important: The appliance comes with a protective
glove - this must be worn (Fig. 4) on the hand used to
wrap the hair around the heating element in order to
protect the fingers. However, the glove does not protect
the fingers if they are exposed to prolonged contact
with the heating element.
· Always test the curling tongs on a small section of
hair first.
· Divide your hair into sections about 2 cm thick and
4 cm wide.
· Hold the curling tongs vertically. Wind the section
around the conic curling tongs from the base to the
tip to create a spiral. (Fig. 4)
· When the entire section has been wound around
the curling tongs, hold it for a few seconds before
carefully removing the curling tongs from the tight
curl. Do not brush or comb hair while it is warm.
· After curling the desired sections of hair in this way,
the curls can be loosened with the fingers and the
hair can be styled.
Tip: To make it easier to curl hair around the neck
area, hold the curling tongs horizontally instead of
vertically.
· To create large curls, wind the section of hair
around the base (Ø25 mm) of the curling tongs
(Fig. 3) and use the tip (Ø13 mm) of the curling
tongs for smaller curls (Fig. 3).
Cleaning and care
· Before cleaning the appliance, disconnect from the
mains and allow it to cool down.
· Do not immerse the appliance in water.
· Only wipe the appliance with a soft cloth, which
may be dampened slightly. Do not use solvents or
abrasives!
Disposal
Adhere to the relevant legal requirements when dispos-
ing of the appliance.
Information on the disposal of electrical and elec-
tronic appliances in the European Community:
Within the European Community, national
regulations are specified for the disposal of
electrical appliances, based on EU Waste
Electrical and Electronic Equipment Directive
2012/19/EC (WEEE). In accordance with this,
the appliance can no longer be disposed of
with the local or domestic waste.
The appliance will be accepted free of charge
by local collection points or recycling centres.
The packaging for this product is made from
recyclable materials. Dispose of this in an
environmentally friendly manner by recycling it.
ENGLISH
de
en
fr
it
es
pt
nl
sv
no
fi
tr
pl
cs
sk
hr
hu
sl
ro
bg
ru
uk
el
ar
9