Digital Tuner; General Operation; Radio Reception - Philips AZ 2010/00 Manual De Instrucciones

AZ 2010 /00 6
page
OPERATION

GENERAL OPERATION

1. Adjust the source selector to your desired sound source: OFF/
TAPE•TUNER•CD.
2. Adjust the sound using the VOLUME, INCREDIBLE
SURROUND and OFF•DYNAMIC BASS BOOST•ULTRA
BASS controls.
3. To switch off the set, adjust the source selector to OFF/TAPE
position and check that the cassette keys are released.
Note: When the set is switched off the tuner presets will be
retained in the set's memory.

RADIO RECEPTION

1. Adjust the source selector to TUNER.
2. Press BAND once or more to select your wave band.
3. To tune to radio stations, press the SEARCH controls ∞ or
§ until the frequency in the display starts running, then
release the control.
Srch appears in the display and the radio automatically
–
tunes to a station of sufficient reception.
4. Repeat if necessary until you find the desired station.
• To tune a weak transmitter, briefly press ∞ or § until
you have found optimum reception or the correct frequency.
– When appears in the display, you are receiving a FM-
STEREO
stereo transmitter.
To improve radio reception
• For FM , pull out the telescopic aerial. Incline and turn the
aerial. Reduce its length if the signal is too strong (very close
to a transmitter).
• For MW (AM) and LW, the set is provided with a built-in
aerial so the telescopic aerial is not needed. Direct the aerial
by turning the whole set.
6

DIGITAL TUNER

TUNER
SWFM FM
MWLWAM AM